For years I have used this mouse, 3,000 hours of Arma 3, 700 of DayZ and many many more from other games. When the cable eventually breaks, I will fit a new USB, when the switches turn to mush I will solder in new switches.
I’m far from a fan boy, especially when it comes to Corsair but the Scimitar, best mouse I have had.
Depends on what you mean by easily.
I would look for a mouse where the screws aren’t covered by the stick on feet. Less can be more, less buttons, less things to break = more stable. Its also good to look at the faulty market: buy a working mouse, and when it eventually breaks source replacement parts from faulty mice from eBay, if the market is stupidly priced or non existent you many need to do some research for which switches are used, this can be difficult to ID.
So stick with mainstream brands like Logitech, Corsair, Razor (not my first choice but there will be no end of faulty mice 😅) but if your up for IDing PCB components then any mouse can be fixable.
Thanks for the reply! I was thinking more along the lines of “open hardware” — either a mouse manufactured by a larger company so that it can be easily repaired, with the manufacturer happy to sell you spare parts (something like Framework laptops), or a mouse designed by an internet enthusiast that you can assemble yourself from off-the-shelf components and 3D-printed parts.
I once saw a build-it-yourself kit for an ultra-light mouse somewhere. I naively assume that such a mouse would be easy to repair. Alas, that kit would cost me my kidney.
Pretty much no manufacturer is going to sell you parts besides maybe replacement feet. But the only things that fail on mice are all jellybean components.
Left mouse button fails? Buy another from mouser. Middle button fails? Digikey. Side button? Some other components selling company.
Outside of those super light mice there’s nothing special about any of them other than the exact layout, and the case. And the cheaper the mouse usually the simpler they are on the inside, and the easier it is to solder. Most PCBs will be single sided with through hole components.